GR30/GM30/GR50, Equipment Setup
49
6.4 Install USB drivers
6.4.1 General
Before you begin Before connecting the instrument to a computer using a USB cable, you must first
install USB drivers. To install the USB drivers refer to the GR/GM USB Driver Installation
Guide available on myWorld.
Only one instrument can be connected to the computer via USB at a time.
6.4.2 Setup via Web Interface over USB
Setup via web
interface over USB
Step Description
1. Turn on the instrument.
2. Start the computer.
3. Loosen the screw on the SD card/USB port cover.
4. Open the SD card/USB port cover.
5. Plug the USB cable into the USB port on the instrument.
6. Plug the USB cable into the USB port of the computer.
7. Open a browser and type in the IP address: 192.168.254.2 to access the
instruments web interface.
8. Use the default User name (Admin) and Password (12345678).
After logging in the first time you must create a new user account,
including a new user name and password. The default user account
can then be deleted. Refer to the "GR/GM Series Operational Manual
(Online Help)" for a step-by-step guide.
9. Configure the instrument for all required settings.
GR10_023
6
5
1
To Next Page
Loading...
Need help?
General
