Lennox Prodigy 2.0 User Manual

Page 2
Table Of Contents
1. Prodigy 2.0 M3 Unit Controller Description Page 6..................................................
1.1. Add-on boards Page 6.....................................................................
2. Main Controller Operation Page 7.................................................................
2.1. System Mode - Thermostat Page 7..........................................................
2.1.1. Cooling Stages Page 7.............................................................
2.1.2. Heating Stages Page 8............................................................
2.2. System Mode - Room Sensor Backup Mode Set Points Page 8..................................
2.2.1. Network Control Panel Page 8......................................................
2.2.2. Room Sensor Back-Up Modes Page 8...............................................
2.2.3 Room Sensor Back-Up Mode Set Points Page 8......................................
2.2.4. L Connection Network Back-Up Mode Requirements Page 11............................
2.2.5. Heating and Cooling Stages in Room Sensor Mode Page 11.............................
2.2.6. Start-Up Delay in Room Sensor Mode Page 11.........................................
2.2.7. Blower Operation (Occupied) in Room Sensor Mode Page 11............................
2.2.8 Room Sensor Parameters Page 11...................................................
3. Unit Component Operation Page 16................................................................
3.1. Compressor Protection and Delays Page 16....................................................
3.1.1 Compressor Minimum Run and Off Times Page 16.....................................
3.1.2. Freeze-stats (S49, S50, S53 and S95) Page 16........................................
3.1.3. High Pressure Switches (S4, S7, S28 and S96) (Standard and High Efficient Units) Page 16....
3.1.5 Thermal Protection Switches (S5, S8, S31 and S180) Page 16.............................
3.1.5. Low Pressure Switches (S87, S88, S97 and S98) Page 17...............................
3.1.6. Loss of Power Detection (Single-Phase Units Only) Page 17.............................
3.2. Gas Units Burner Protection and Delays Page 17...............................................
3.2.1. Primary or Secondary Limits (S10 and S99) Page 17....................................
3.2.2. Roll-Out Switch (S47 and S69) Page 17...............................................
3.2.3. Combustion Air Inducer Proof Switch (S18 and S45) Page 18............................
3.2.4. Gas Valve Sensor Page 19..........................................................
3.2.5. Gas Heat Valve Delays Page 19......................................................
3.3. Miscellaneous Components Page 19..........................................................
3.3.1. Thermostat Bounce Delay (Local Thermostat Mode Only) Page 19........................
3.3.2. Return Air Temperature Limits Page 19................................................
3.3.3. Smoke Detector (A171 and A172 - Optional) Page 19...................................
3.3.4. Safety Switch Input (A42 - Optional) Page 20..........................................
3.3.5. Air Flow Proving Switch (S52 - Optional) Page 20......................................
3.3.6. Dirty Filter Switch (S27 - Optional) Page 20............................................
3.3.7 Blower Overload Relay Switch (S42 - Optional) Page 20.................................
3.3.8 Overflow Switch (S149 / S179 - Optional) Page 20......................................
3.3.9. Blower On-Delay Page 20...........................................................
3.3.10 Blower Off-Delay Page 20...........................................................
3.3.11. Unoccupied or Night Setback Mode Page 21...........................................
3.3.12. Wired Thermostat Mode Page 21.....................................................
3.3.13. Room Sensor Mode Page 21........................................................
3.3.14. Gas and Electric Heat Warm-Up Mode (During Occupied Time Period) Page 21............
3.3.15. Cool-Down Delay (During Occupied Time Period) Page 21...............................
3.4. Gas Heat Operation—Gas Units Page 21......................................................
3.5. Electric Heat Operation—Electric / Electric Units Page 22........................................

Lennox Prodigy 2.0 Specifications

General

Brand	Lennox
Model	Prodigy 2.0
Category	Controller
Language	English