4. Turn the computer over and tighten the screws to secure the keyboard.
5. Connect the ac power adapter and all disconnected cables to the computer.
Service bracket
Prerequisite
Before you start, read
Generic Safety and Compliance Notices and print the following instructions.
Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get
damaged.
For access, do the following:
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 47.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the keyboard. See “Keyboard” on page 49.
Chapter 6. CRU replacement 53
To Next Page
Loading...
Need help?
General
