M.2 solid-state drive
Prerequisite
Before you start, read Chapter 1 “Important safety information” on page 1 and print the following
instructions.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
Replacement procedure
1. Remove the power cord. See “Power cord” on page 66.
2. Remove the left side cover. See “Left side cover and right side cover” on page 66.
3. Remove the microprocessor heatsink and fan assembly. See “Microprocessor heatsink and fan
assembly (for selected models)” on page 72.
4. Loosen the screw holding the M.2 heatsink.
Note: Do not touch the thermal paste while handling the heatsink.
5. Remove the M.2 mounting screw holding the M.2 solid-state drive in place.
6. Remove the M.2 heatsink.
7. Remove the M.2 solid-state drive from the M.2 slot.
8. Perform the removal procedure in reverse to reinstall a new CRU.
Microprocessor heatsink and fan assembly (for selected models)
Prerequisite
Before you start, read Chapter 1 “Important safety information” on page 1 and print the following
instructions.
72
Lenovo Legion Tower 5 (26L, 5)Hardware Maintenance Manual
To Next Page
Loading...
Need help?
General