Replacing CRUs 24
Replacing the computer stand
Note
The computer stand is available only on some models.
1
Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the computer.
2
Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently
lay it down so that the screen is against the surface and the computer cover is facing up.
3
Replace the computer stand.
• Tilt-only stand
1 2
3
4
To Next Page
Loading...
Need help?
General