Lenze SX-1 User Manual

5.3.5 __
5.3.5 SX-1 Internal Adjustments
The SX-1 may be adapted forvarious operating conditions by Internat coding switches and
jumpers (links). For the location of the switches and jumpers on the card, see the diagram
at the end of this section <page 5/22).
On Front Panel:
• Switch S2: Axis Number Selection for Normal Operation (Standard). The switch is below
the Status Display LED: with it, you can select numbers in the range 0- 15. The axis Ad -
dress is internat and is valid for the serial link X3.
S3 Section 4 = ON
On the Motherboard:
Block selection:
Extension of address
in 1 6-fotd steps 16-63
<binary coded).
S4-1 oft = axis range 16-31
ON=
multi turn
OFF=
single turn
Absolute Encoder
Special Modes for Internal Acldressing:
When interpolating, only addresses 0 - 3 are permitted, but since several interpolation
groups may be connected to a serial communications link, the following options are
pro vi ded:
S3 section 4 = 0FF
The Interpolation address is selected on the Front Panel <address 0-3), and the Serial
Communications Link address with S4 sections 1-5 (address 0-31).
5/18
Output A7 for
„In Position“
(switch off)
Lanze

Lenze SX-1 Specifications

General

Brand	Lenze
Model	SX-1
Category	Industrial Equipment
Language	English