Software Version 2.0 Release & Errata Notes
MC-12
33
15. References to the INPUT GAIN parameter on page 3-7 of the
MC-12 User Guide (Rev 1) refer to the ANLG IN LVL menu
AUTO GAIN parameter.
16. The factory-default setting of the MAIN ADV menu
COMPONENT OSD parameter is OFF. When set to ON, the
component on-screen display appears on a full blue-screen
background. Refer to page 3-14 of the MC-12 User Guide (Rev
1) for more information.
17. When the CUSTOM SETUP or THX SETUP menu REAR L/R
parameter is set to NONE, the MC-12 redirects rear channel
signals to the MAIN AUDIO OUTPUTS labeled SIDE L/R. Refer
to page 3-21 of the MC-12 User Guide (Rev 1) for more
information.
18. The SUB LIMITERS menu has been renamed the BASS PEAK
LIMITERS menu. The menu and its parameters still function as
described on pages 3-28 and 3-29 of the MC-12 User Guide
(Rev 1).
19. The 5.1 MONO, 5.1 MONO LOGIC, and 5.1 MONO SURR
listening modes are designed for playback of Dolby Digital
mono input sources. When a Dolby Digital 1.0 input source is
present, the MC-12 automatically selects the 5.1 MONO
LOGIC listening mode. The MC-12 does not automatically
select 5.1 MONO LOGIC for other Dolby Digital mono input
sources.
20. The front panel Mute button LED lights whenever mute is
automatically or manually activated. For instance, the MC-12
will briefly activate mute when switching input sources or
listening modes.
21. When a new software version is installed, INPUT SETUP menu
preferred listening mode selection parameters that were set to
USE LAST will not revert to the listening mode that was last
selected. Instead, these parameters will revert to the default
listening modes shown in the table below.
Parameter Default Value
2-CH LOGIC7 MUSIC
DOLBY D 5.1 LOGIC7 FILM
dts(-ES) dts(-ES) LOGIC7 FILM
5.1a 5.1a LOGIC7 MUSIC
22. When the INPUT SETUP menu 2-CH parameter is set to USE
LAST and the remote control 2CH button is pressed to select
the 2-CHANNEL listening mode, the MC-12 will revert to the
listening mode that was selected prior to the 2-CHANNEL
listening mode when the selected input is deselected, then
reselected.
@@@
REVISED MENU TREE
The menu tree that begins on the next page is based on Software
Version 2.0. It replaces menu trees that appear in all previous
documentation.
. . . Revised Menu Tree continues on page 34
v2.0
To Next Page
Loading...
Need help?
General
