3-9
Controlling the LXP-15
Owner's Manual Addendum
6. Confirm that the LXP-15 is set to receive on the same MIDI channel as
the displayed “CH#”.
7. Press ENTER to put the MRC into Machine Run Mode. The MRC display
will change to show the first page of LXP-15 Setup parameters.
8*.To set the LXP-15 to the same state as the MRC, press ✱ to send the
MRC Setup parameters to the LXP-15. The parameter values displayed
by the LXP-15 will change to match those displayed by the MRC.
OR
To set the MRC to the same state as the LXP-15, press ENTER on the
MRC to send the LXP-15 parameters to the MRC. The parameters
displayed by the MRC will change to show the values received from the
LXP-15.
9. You can confirm that two-way communication has been established by
changing any parameter value from the LXP-15 front panel and then
pressing ENTER on the MRC. The appropriate parameter display on the
MRC will change to show the new value.
* (Step 8 only needs to be done the first time communication is established
between the two units.)
With two-way communication, you can update the MRC values to match
those currently active in the LXP-15. This is particularly useful if you’ve
changed the LXP-15 at the front panel and want to transfer the new settings
to the MRC for further editing. To update the MRC, simply press ENTER at
any time while in Machine Run Mode. This will automatically transfer and
display the active LXP-15 parameters.
To Next Page
Loading...
Need help?
General