4-8
Lexicon MRC V4.0/ MIDI Remote Controller
3. Press ENTER to put the MRC into Machine Run Mode.
4. Press SETUP to enter Setup Select Mode.
5. Use the leftmost slider, the SETUP button, or the keypad to select the
desired setup.
Pressing ∗ on the keypad switches the display between “SETUP#”
and “EXTRN#”. While “SETUP#” is displayed, you can use the
keypad to select any internal setup (1–16). While “EXTRN#” is
displayed, you can use the keypad to select any external setup (1–
128).
6. Press ENTER to load the setup into the MRC and LXP-5.
Communication Problems
If the MRC is unable to communicate with the LXP-5, it will display one of two
error messages: “No Target,” or “SYNCH TIMEOUT.” The “No Target”
message is displayed if the MRC cannot “find” the LXP-5. This can occur if
the LXP-5 is not connected properly or if it is set to a different MIDI channel
than the MRC. To recover from a “No Target” error, it is necessary to re-
establish communication with the LXP-5. To do this, repeat the procedure
in
Establishing Two-way Communication
.
The “SYNCH TIMEOUT” message is displayed if MIDI MERGE for the IN/
OUT ports connected to the LXP-5 is set to “ON,” or when MIDI data is
received faster than it can be processed by the MRC. To recover from a
“SYNCH TIMEOUT” error, simply press ENTER (and confirm that MIDI
MERGE is set to “OFF”).
Viewing and Editing LXP-5 Setup Parameters
LXP-5 setup parameters are viewed and edited on seven MRC display
pages.
Pages can be selected by pressing PAGE repeatedly, or by pressing
the desired page number on the key pad.
To edit LXP-5 parameters from the MRC, simply select the desired page and
move the slider of the parameter you want to edit. The new value is displayed
on the MRC and transmitted to the LXP-5. (You will see the LEARN LED
To Next Page
Loading...
Need help?
General