Registering Magic Motion Remote
Control
The Magic Motion Remote Control operates by
pairing with your TV.
Register the Magic Motion Remote Control to use
it.
How to register the Magic Motion Remote
Control
To register the remote control, press the
ENTER
button on the remote control while aiming it at
your TV.
How to Re-register the Magic Motion Remote
Control after Registration Failure
Reset the remote control by pressing and holding
both the
ENTER
and
MUTE
buttons for 5 seconds.
(Once the reset is complete, the light on the
Pointer blinks.) Then repeat the above procedure
to register the remote control.
How to use Magic Motion Remote
Control
1
Press
ENTER
button if there is no pointer on
your TV screen. The pointer will then appear on
the screen.
If the pointer has not been used for a certain
period of time, it will disappear.
2
You can move the pointer by aiming the
Pointer Receiver of the remote control at your
TV then move it left, right, up or down.
If the pointer does not work properly after
clicking the
ENTER
button, leave the remote
control for 10 seconds then use it again.
Precautions to Take when Using
the Magic Motion Remote Control
Use the remote control within the maximum
communication distance (10 m). Using the
remote control beyond this distance, or
with an object obstructing it, may cause a
communication failure.
A communication failure may occur due to
nearby devices. Electrical devices such as
a microwave oven or wireless LAN product
may cause interference, as this will use the
same bandwidth (2.4 GHz) as the Magic
Motion Remote Control.
The Magic Motion Remote Control may be
damaged or may malfunction if it is dropped
or receives a heavy impact.
When playing a game using the Magic
Motion Remote Control, hold it securely by
wrapping its strap around your wrist and
adjusting the length with the adjustable ring.
Take care not to bump into nearby furniture
or other people when using the Magic
Motion Remote Control.
Manufacturer and installer cannot provide
service related to human safety as the
applicable wireless device has possibility of
electric wave interference.
It is recommended that an Access Point
(AP) be located more than 1 m away from
the TV. If the AP is installed closer than 1
m, the magic motion remote control may
not perform as expected due to frequency
interference.
37
ENG
ENGLISH
REMOTE CONTROL
To Next Page
Need help?
General
Weight and Dimensions
