57
SERIAL COMMUNICATION FUNCTION
SERIAL COMMUNICATION
FUNCTION
Using Serial Communication
If the projector is connected to a PC through an RS-232C cable, you can
use the PC to control functions of the projector such as power On/Off or
input selection, etc.
It cannot be used with the eZ-Net Manager
concurrently. For
serial commu-
nication, set LAN to Off in the eZ-Net Manager.
This function may not be available for a particular menu or input mode.
Establishing Serial Communication
Connect the RS-232C (serial connector) of the PC to the RS-232C connector at
the back of the projector.
You need to purchase a cable to connect the RS-232C connectors as it is not
provided as an accessory.
* A RS-232C cable is necessary for the remote control of the projector (see Figure 1).
2
3
4
5
6
7
8
PC
RXD
TXD
TXD
DTR
DTR
GND
GND
DSR
DSR
RTS
RTS
CTS
CTS
RXD
9 6
15
Projector
* There is no connection to Pin 1 and Pin 9.
[Figure 1] RS-232 Connection Diagram
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
