15
Installing the micro SIM card
Before you can start exploring your new phone,
you’ll need to set it up. The micro SIM card
tray eject button is a small round aperture just
above the tray door. To install a new micro
SIM card:
1 Insert the micro SIM ejection tool that
comes with the phone (or a thin pin) into the
eject button aperture and push gently but
firmly until the tray pops out. Then pull the
micro SIM card tray.
Eject button aperture
2 Position the micro SIM card into the tray (as
shown in the above image).
3 Insert the micro SIM card tray.
%
NOTE
Turn the phone off before inserting or removing
the micro SIM card.
%
Warning
Always be careful when removing the
micro SIM card tray. The ejection tool is
very sharp.
Charging your phone
1 Connect the wall adapter and USB cable as
shown below. The USB symbol on the USB
cable should face toward you.
2 Plug the USB cable (as shown below) into
the phone's Charger/Accessory Port. Make
sure the USB symbol is facing upwards.
Always unplug the charger from the wall
socket after the phone is fully charged to
save unnecessary power consumption of
the charger.
Getting Started
To Next Page
Loading...
Need help?
General
