MMX4x2 series – User's Manual 38
Install and Update
ATTENTION! Please note that the minimum system requirement is 1 GB RAM and the minimum display
resolution shall be 1280x720.
ATTENTION! Certain ports are used for the communication in the background; please check the list in the
Applied Ports (Network Settings) section.
INFO:
version with the same attributes.
Installation for Windows OS
Run the installer. If the User Account Control drops a pop-up message, click Yes. During the installation you
will be prompted to select the type of the installation: normal and the snapshot install:
Normal install Snapshot install
The installer can update only this instance Cannot be updated
Only one updateable instance can exist for
all users
More than one different version can be
installed for all users
Comparison of installation types
ATTENTION! Using the Normal install as the default choice is highly recommended.
Installation for macOS
ATTENTION!
exeptions of the blocked softwares for the proper operation.
over the desired folder.
Updating of LDC
Step 1. Run the application.
The Device Discovery window appears automatically, and
updates.
The current and the update version number can be seen
at the top of the window and they are shown in this
window even with the snapshot install.
The Update window can also be opened by clicking on
the About icon
and the Update button.
Step 2. Set the desired update setting in the Options section.
▪ If you do not want to check for the updates
automatically, uncheck the circle that contains the
green tick.
▪ If you want to postpone the update, a reminder can be
set with different delays from the drop down list.
▪ If the proxy settings traverse the update process, set
the proper values, then click on the OK button.
Step 3. Click on the Download update button to start the
update.
The updates can be checked manually by clicking on the
Check now button.
Running the LDC
The common way to start the software is to double-click
line parameters as follows:
Connecting to a Device with Static IP Address
static IP address directly; the Device Discovery window
Format: LightwareDeviceController -i <IP_address>:<port>
Example: LightwareDeviceController -i 192.168.0.20:6107
Connecting to a Device via a Serial Port
displayed. If no Baud rate is set, the application will detect it automatically.
Format: LightwareDeviceController -c <COM_port>:<Baud>
Example: LightwareDeviceController -c COM1:57600
Adjusting the Zoom
default value (100%).
Format: LightwareDeviceController -z <magnifying_value>
Example: LightwareDeviceController -z 1.2
ATTENTION!
To Next Page
Loading...
Need help?
General
