ENTRY DELAY (For Entering the Premises)
★ The Entry Delay gives you 45 seconds to
enter the premises
through a delayed
perimeter door without triggering an alarm.
★ If a perimeter delayed sensor is triggered,
starting the Entry Delay, the interior sensors
will also become delayed (this allows motion
in the premises during the Entry Delay).
◗ During the 45 second Entry Delay, the
Console will sound “beeps”.
★ When the Entry Delay is over, the Console
will go into full alarm and sound the siren if it
is not disarmed to the Off or Chime Mode.
✔ If an alarm has occurred while you
were gone, multiple beeps will sound
after disarming and the sensor light for
the sensor(s) that caused the alarm will
flash (switch to Off Mode again to stop
flashing alarm memory light).
☞
If you hear the multiple beeps, use
caution when entering. AN
INTRUDER MAY STILL BE IN YOUR
HOME.
✍ NOTE: The Entry Delay time can be
changed; see the Advanced Programming
Section of this manual.
AUTOMATIC BYPASSING OF SENSORS
★ The Console can be armed with open door
or window sensors.
◗ The system will automatically “bypass” open
doors and windows after sounding four
high-low beeps to warn you that a protected
door or window is open.
◗ Lit sensor status indicators show which
sensors are open.
✍ NOTE: Bypassed sensors cannot cause an
alarm until they are “restored”.
★ If you close the door or window after arming
the system, the sensor will be restored and can
cause an alarm the next time it is opened.
★ Automatic bypassing of sensors in the Away
Mode allows you to arm the system with
open doors and windows, while still having
perimeter protection with other closed doors
and windows.
21 OF 40
45
SECONDS
Defiant SSD DF-16 Owner’s Manual
Linear P/N: 208968 C
Material: 20# White Mead Bond with 60# White Coated Cover
Ink: PMS 548 (Blue/Gray)
Size: 8 1/2" x 5 1/2"
19
To Next Page
Loading...
Need help?
General
