17. ADVANCED PROGRAMMING
LEARN MODE
★ To perform any of the advanced
programming steps, the Console must be in
the Learn Mode.
☞Start with the Console in Off Mode (Learn
Mode cannot be reached from any other
mode).
☞Enter Learn Mode by entering your secret
code and pressing the [LEARN] button.
✍ NOTE: Only the master secret code can be
used to put the Console into the Learn
Mode. The restricted secret code cannot
access Learn Mode.
◗ A “gong” and five “beeps” will sound,
signaling that the Console is in Learn Mode.
☞Hold the [OFF] key for three seconds when
you want to exit Learn Mode.
✍ NOTE: If the Console is left unattended in
Learn Mode, it will automatically switch back
to Off Mode after three minutes.
ENTRY DELAY TIME
★ The factory-set Entry Delay time is 45
seconds.
★ The Entry Delay time can be adjusted from
one to 255 seconds.
✍ NOTE: Don’t make your Entry Delay too
short. You may not have enough time to
disarm the system before an alarm.
★ The Console must be in Learn Mode to
make this change.
☞Exit Learn Mode when all programming
changes are complete.
EXIT DELAY TIME
★ The factory-set Exit Delay time is 30 seconds.
★ The Exit Delay time can be adjusted from
one to 255 seconds.
★ The Console must be in Learn Mode to
make this change.
☞Exit Learn Mode when all programming
changes are complete.
28 OF 40
START IN OFF
YOUR
SECRET
CODE
LEARN MODE
1 GONG &
5 BEEPS
TIME IN SECONDS (1-255)
PROGRAMMING STEP #20
PROGRAM
STORE PROGRAM
TIME IN SECONDS (1-255)
PROGRAMMING STEP #21
PROGRAM
STORE PROGRAM
Defiant SSD DF-16 Owner’s Manual
Linear P/N: 208968 C
Material: 20# White Mead Bond with 60# White Coated Cover
Ink: PMS 548 (Blue/Gray)
Size: 8 1/2" x 5 1/2"
26
To Next Page
Loading...
Need help?
General
