19
Chapter 6: Set Up and Configure the Router
Overview
10/100 4-Port VPN Router
Firewall Tab
• General. From the Firewall Tab, you can configure the Router to deny or allow specific internal users from
accessing the Internet.
• Access Rules. Network Access Rules evaluate the network traffic's Source IP address, Destination IP address,
and IP protocol type to decide if the IP traffic is allowed to pass through the firewall.
• Content Filter. This tab allows you to filter web access by site and time.
VPN Tab
• Summary. The VPN Summary displays the Summary, Tunnel Status and GroupVPN Status.
• Gateway to Gateway. By setting this page, users can add a new tunnel between two VPN devices.
• Client to Gateway. By setting this page, you can create a new tunnel between a Local VPN device and a
mobile user.
• VPN Pass Through. This tab allows you to disable IPSec Pass Through, PPTP Pass Through, and L2TP Pass
Through.
Log Tab
• System Log. The System Log displays Syslog, E-mail and Log Settings.
• System Statistics. This tab displays the system statistics.
Wizard Tab
• Wizard. Use this tab to access two Setup Wizards, the Basic Setup Wizard and Access Rule Setup Wizard.
Support Tab
• Support. This tab supplies buttons to access the user guide and the Linksys website.
Logout Tab
• Logout. Clicking this tab exits you from the Utility.
To Next Page
Loading...
Need help?
General
