18
Adding Salt
If the water in your area is hard, deposits will form on your dishes
and utensils. This appliance contains a salt reservoir for you to
reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt
reservoir and it must be set to correspond to the water hardness
level in your area.
1. Remove the lower basket and unscrew the reservoir
cap.
2. Fill the reservoir with approximately 500ml of water
(rst use only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt
depending on the brand used.
5. Clean any excess salt from around the reservoir opening
and then screw the cap on again rmly.
6. Run the “Rapid” wash programme immediately (without
any crockery in the dishwasher) to remove any traces of
salt from the compartment.
open
open
open
• Salt rell warning indicator will illuminate when the reservoir is running out of salt
and requires relling.
• The salt rell warning indicator will cease to illuminate within a few days, depending
on how quickly the salt dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends
upon the water hardness in your area and the type of tablet being used. Check with
your water supplier and the detergent tablet manufacturer’s instructions.
LID60W20_IB_RC_Final210603.indd 18LID60W20_IB_RC_Final210603.indd 18 3/6/2021 5:42 PM3/6/2021 5:42 PM
To Next Page
Loading...
Need help?
General
