EasyManuals Logo
Home>Logik>Dishwasher>LID60W20

Logik LID60W20 User Manual

Logik LID60W20
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
33
Rapid programme indicator
blinking rapidly (blink 5
times faster than normal
operation blinking)
Water tap is not turned on. Turn on the water tap.
Low water pressure
(<0.04 MPa)
Turn on the water tap and ensure
it is in full position.
Flow meter is broken.
Disconnect from the mains.
Disconnect the water inlet.
Call a qualified technician.
The wire terminals which
connect the flow meter are
loose.
Glass programme indicator
blinking rapidly (blink 5
times faster than normal
operation blinking)
The tank is leaking.
The hose is leaking.
The float switch is broken
or PCB is faulty.
General Problems
Problem Possible Causes Remedy
Detergent residue is left in the
dispenser at the end of the
programme.
The detergent dispenser was still
damp when detergent was added.
Make sure the dispenser is dry before
adding detergent.
The detergent dispenser lid cannot
be closed properly.
Clogged detergent residue is
blocking the catch.
Clean the catch.
Knocking noise in the wash
cabinet.
A spray arm is knocking against an
item in a basket.
Interrupt the programme, and rearrange
the items which are obstructing the
spray arm. See the section “Loading the
Dishwasher”.
Smearing appears on glassware
and cutlery.
The rinse aid dosage is too high.
Adjust the rinse aid dosage to a lower
dosage.
Dishes, cutlery and glasses are
not dry.
The amount of rinse aid may
be insufficient, or the rinse aid
reservoir is almost empty.
Replenish the reservoir or change the
brand of rinse aid.
Crockery was taken out of the
dishwasher too soon.
Leave the crockery in the dishwasher until
you hear an audible sound.
White residue is visible on cutlery
and crockery, clouding occurs on
glassware; film can be wiped off.
Not enough rinse aid was used.
Replenish the reservoir or change the
brand of rinse aid.
There is not enough salt in the salt
reservoir.
Fill the salt reservoir.
The salt reservoir cap has not been
screwed on correctly.
Ensure that it is screwed back on correctly.
Unsuitable detergent has been
used.
Change your detergent. Use a dishwasher
standard powder detergent.
The salt consumption setting is
too low.
Select a higher salt consumption setting.
Glassware is dull and discoloured;
film cannot be wiped off.
The glassware is not dishwasher
proof. The surfaces are affected.
Wash the non-dishwasher proof glassware
by hand.
LID60W20_IB_RC_Final210603.indd 33LID60W20_IB_RC_Final210603.indd 33 3/6/2021 5:43 PM3/6/2021 5:43 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik LID60W20 and is the answer not in the manual?

Logik LID60W20 Specifications

General IconGeneral
BrandLogik
ModelLID60W20
CategoryDishwasher
LanguageEnglish

Related product manuals