31
Spray Arms
Particles of food can get stuck in the spray arm jets and
bearings. The spray arms should therefore be checked
and cleaned regularly.
1. Ensure the dishwasher is switched o.
2. Check whether or not the holes for the upper
and lower spray arms are clogged. If there is any
clogging, remove the spray arms and clean them
under running water.
3. You can remove the lower spray arm by pulling it
upwards, while the upper spray arm can be removed
by holding the nut and rotating the upper arm
clockwise.
4. Be sure that the nut is perfectly tightened when
retting the upper spray arm.
Frost Precaution
Avoid placing the dishwasher in a location where the temperature can get below 0°C. If your
appliance is left in an unheated place over the winter, you are advised to:
1. Disconnect the unit from the water inlet.
2. Turn on the unit. Select any washing cycle and let it run for 1 minute only. This drains out all
the excessive water that remains in the unit.
3. Disconnect from the mains socket.
4. Empty the dishwasher.
5. Close the dishwasher door.
6. Disconnect the unit from the water drain. Use a suitable receptacle to catch any residual
water in the pipes.
Should you encounter any diculties with the above steps, please ask a service technician for
assistance.
Moving the Dishwasher
If you have to move the unit, for instance due to moving house, you are advised to:
1. Disconnect the dishwasher from the mains.
2. Disconnect the dishwasher from the water inlet and drain. Use a suitable receptacle to catch
any residual water in the pipes.
3. Remove the dishwasher from the current location with the hoses discharged.
4. Pull the unit out together with the hoses.
• Avoid over tilting the unit during transportation.
• We recommend that 2 people handle the dishwasher during installation.
LID60W20_IB_RC_Final210603.indd 31LID60W20_IB_RC_Final210603.indd 31 3/6/2021 5:43 PM3/6/2021 5:43 PM
To Next Page
Loading...
Need help?
General
