27
Delay Start
The starting time of a washing programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Press the On/O button to turn on the dishwasher.
3. Select your preferred programme.
4. Set the required delay start time using the Delay button.
5. Close the door. The unit will start the programme at the assigned delay hour automatically.
Half Load
In case you do not have enough dishes for a full load, the half load option can be selected. This
will save hot water and electricity usage. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Press the On/O button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the 1/2 button.
5. Close the door and the unit will start the programme.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the On/O button.
If the dishwasher is not going to be used for a long period of time, e.g., you are going
on holiday, please disconnect the dishwasher from the mains supply and switch o the
water supply.
Unload the lower basket rst, followed by the cutlery basket and then the upper basket.
This will prevent water drops from the upper basket from falling onto the dishes in the
lower basket.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip
more easily when they are hot. Therefore, if you open the dishwasher door fully after switching
o, it will allow the dishes to cool down much faster.
LID60W20_IB_RC_Final210603.indd 27LID60W20_IB_RC_Final210603.indd 27 3/6/2021 5:43 PM3/6/2021 5:43 PM
To Next Page
Loading...
Need help?
General
