4 -1
(1) Check points
※ For new tractor, the followings must be checked once again even though there was sufficient quality
management, inspection, regulating of each part in the factory.
Appearance check
- Is there any damage while transporting?
Engine cooling system check
- Is there anti-freeze solution in the radiator? And any leakage?
- Avoid prolonged operation at either high or low engine speeds without a load on the engine.
- Check the instruments frequently and keep the radiator and oil reservoirs filled to recommended
levels. Daily checks include the engine oil level, radiator coolant, and air cleaner.
- After using the first 50 hours, be sure to perform the maintenance items listed in the maintenance
schedule. Refer to the chapter 5-4, “First 50 hour check” in this manual. If possible, contact your
authorized local dealer for “First 50 hour check”.
(2) Notices in handling new tractor (Engine brake-in procedure)
To get the best performance, comply with the followings.
- DO NOT start or stop the tractor suddenly.
- DO NOT operate heavy loaded work and do
not increase the engine rpm to high speed
suddenly.
- Despite warm ambient temperature, warm up
the engine for about 5 minutes at low idle rpm.
- Use the lower gear ratios when pulling heavy
loads and avoid continuous operation at
constant engine speeds. You will save fuel and
minimize engine wear by selecting the correct
gear ratio for a particular operation
Fuel system check
- Is there any leakage of fuel in the fuel system?
Oil level check
- Is there optimal oil amount in each part ?
Electric system check
- Is there any cut-off or any other problem in the
wiring?
- Is there any problem to operate the instruments?
- Is the state of battery charging sufficient?
4-1. How to handle new tractor
4. Operation and Work
To Next Page
Loading...
Need help?
General
