LS tractor MT342 User Manual

5 -33
(4) Checking Front axle oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around the oil gauge and oil filling inlets.
 Open the oil gauge and check if the oil level is
marked between “Maximum” and “Minimum”
marks on the oil gauge.
 If necessary, add new oil into the oil filling inlet
after removing the oil check port plugs on both
sides.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil filling inlet
& Oil gauge
Oil check port &
oil filling inlet
(3) Checking Transmission oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around oil filling inlet and pull the gauge
straight out.
 If oil level is between “Min” and “Max” marks of
oil gauge, it means ‘Proper amount’.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
▶ Contaminated oil may reduce the durability of power drive lines and it can cause a
failure of the transmission and hydraulic system. Clean around the oil filling inlet
before opening the oil gauge.
Caution
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
(5) Battery check
 Refer to the chapter 5-15-(3), “Batter handling and Notices” in this manual. (See page 5-53)
(6) Air cleaner (Dry type)
 Refer to the chapter 5-6-(6) in this manual (See page 5-24).
▶ Contaminated oil may reduce the durability of power drive lines and it can cause a
failure of the front axle. Clean around the oil filling inlet before opening the oil gauge.
Caution

LS tractor MT342 Specifications

General

Brand	LS tractor
Model	MT342
Category	Tractor
Language	English