3 -22
(12) Throttle lever
This lever is used to control engine speed.
- Pull it backward for Low speed,
- Push it forward for High speed.
For mechanical models, this throttle lever must
be used only for work field. When driving on the
road, place the throttle lever to the low speed
position, and use the throttle pedal.
For HST models, An electronic control sensor is
attached on this lever. If there is an error related
to this sensor while the engine is running, the
engine speed will be fixed to 1500 rev/min, so
called LIMP HOME mode. Contact your
authorized local dealer.
Throttle lever
▶ The shuttle lever allows any forward range or reverse to be shifted while the tractor
is moving slowly. However, the clutch must be disengaged and engaged by means
of clutch pedal or push button switch. Make sure to depress clutch pedal fully or
press the push button switch, and release it gradually to take up load smoothly, but
sudden gear shifting may cause transmission damage. It is recommended to stop
the tractor before operating the shuttle lever.
Caution
To Next Page
Loading...
Need help?
General
