1. Move: the shade to the desired lower limit.
On the remote, use the OPEN, CLOSE, LEFT or RIGHT, ARROW to fine
tune desired position.
On the motor, use the manual control button or dry
contact input (M40 Series only).
2. Remote: press and hold STOP for 6 seconds to put the remote
into program mode.
The backlit buttons on the remote will flash to indicate it is in program
mode.
3. Remote: deselect all GROUP numbers.
4. Motor: press and hold the manual control button located on the
motor head.
5. Remote: while continuing to press the manual control button,
press and release CLOSE on the remote.
The shade will move twice to indicate the lower limit is set.
6. Motor: release the manual control button.
7. Remote: press and hold STOP for 6 seconds to exit program
mode.
The lights will stop flashing.
IMPORTANT: Verify that the lower limit is set. If not,
deselect all GROUP numbers and repeat Step 4.
NOTE: After the upper and lower limits are set, the motor will have one
Favourite position, which is set at 50% open by default. Setting a new Favourite position overwrites any previous
setting.
To Next Page
Loading...
Need help?
General
