12
12
Swim Spa
JETS AND AIR CONTROLS
Swim Area Jets
Swim Spa Turbo Swim jets are designed to
produce a smooth ow of water with high
output to create a consistent swim stream.
Whether you want to swim or walk/jog against
the force of the jets, you will nd the ow of
water deep enough and swift enough to meet
your individual needs.
Hydrotherapy Area Jets
All of the hydrotherapy jets are individually
engineered to provide a unique hydro-
massage. Depending on the model, your Swim
Spa will have a combination of the following
jets:
Cyclone Therapeutic
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on large muscle groups,
these jets deliver a concentrated, high volume
stream of water for a deep massage. Each jet
is fully adjustable, allowing users to set the
water ow to the most comfortable setting.
The nozzle can be rotated to target sore
muscle areas.
Cyclone Turbo Swirl Jets
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on muscle tension zones,
these jets deliver a spinning V-shaped water
stream for a gentle, pulsating massage. Each
jet is fully adjustable, allowing users to set
the water ow to the most comfortable setting.
Cluster Jets:
Positioned in the foot well or shoulder areas of
the Swim Spa, these jets deliver a penetrating
massage to dissolve tension. This jet may be
the entry point for ozone produced during the
automatic ltration cycles, and, as such, is not
adjustable.
Note: Ozone production is suspended when
other functions are activated on the control
panel by the Swim Spa user.
All full sized jets are adjustable from a fully
open to closed position. It is very important
that you NEVER SHUT ALL FULL SIZED JETS
OFF AT ONE TIME!
Cleaning or Replacing Jets
Hard water can cause calcium/mineral buildup
that can restrict or bind the jets. A jet consists
of a face plate and a nozzle. Rotate these parts
weekly and remove/clean monthly to ensure
free movement.
NOTE: It is not necessary to drain the pool
or spa to clean or remove the jets.
Rotating the jet face plate and nozzle
• Rotate the jet face left and right
(open and closed).
• Return the face plate to the full open
position.
• Turn the jets on to high speed.
• Twist the nozzle left and right.
• Rotate the nozzle in the socket.
NOTE: If the jet insert disengages from the
Swim Spa housing, see steps to reinstall
below.
Cleaning the jets
To remove the jet insert, use the palm of your
hand to exert pressure on the face of the jet.
Turn counterclockwise until the jet ‘clicks’.
To Next Page
Loading...
Need help?
General
