13
13
Swim Spa
Gently pull the jet assembly from the housing.
To clean the jet insert and housing, use a
pressurized hose and spray the inside of the
jet. Soak the jet in a diluted Swim Spa cleaning
solution, rinse. Wipe the inside of the housing
to remove any debris.
To reinstall the jet, line up the tab on the
backside of the barrel with the groove in the
body. Use the palm of your hand to gently tab
the jet until it snaps into position.
Air Controls
The intensity of the jet action can be
controlled by altering the amount of air
injected with water through the jets. Your
Swim Spa has 2 to 4 air controls located on the
lip of the Swim Spa. Each control activates air
to speci c jets in the Swim Spa allowing you
to create various combinations and levels of
jet action to suit individual preferences. Turn
the control counter- clockwise to turn the air
o and clockwise to turn air on.
NOTE: Air controls should be closed during
heating cycles for maximum energy
e ciency.
To Next Page
Loading...
Need help?
General
