MAAX xstream User Manual

19
19
Swim Spa
When the control panel lock is engaged, all
automatic Swim Spa functions will operate
normally but cannot be altered.
Panel Unlock
To unlock the panel, touch the TIME, JETS
1, and DOWN within 3 seconds. The ‘PL’
indicator light will go out when the panel lock
is cleared.
Light
Touch the LIGHT pad to turn the digital
lighting system on and o . The light will
automatically turn o after 60 minutes of
operation.
Operating Modes
Your Swim Spa comes with three primary
operating modes.
Standard Mode maintains the water at the
desired set temperature. Note that the last
measured Swim Spa temperature displayed
is current only when the pump has been
running for at least 2 minutes. The pump will
run for approximately 2 minutes every 30
minutes to test the water temperature. The
‘STANDARD’ icon will be displayed in the LCD
window when this mode is selected.
Economy Mode heats the water to the desired
set temperature ONLY during  lter cycles.
The ‘ECONOMY’ icon will be displayed in the
LCD window when this mode is selected.
While in the Economy mode, pressing the
JETS 1 button will put the Swim Spa into the
Standard-In-Economy mode, which operates
the same as the Standard Mode, then reverts
back to the Economy mode after 1 hour. The
Swim Spa can be immediately reverted back
into the Economy mode at any time by simply
is timed to automatically turn o after four
hours of operation.
The high speed operation of Pump 1, and the
low and high speed operation of Pump 2 and
Pump 3, is timed to automatically turn o after
15 minutes of operation.
Note: Pump 1 will automatically operate in
low speed whenever the Swim Spa calls for
a  ltration cycle or heat.
When this automatic activation occurs, the
low speed of Pump 1 cannot be turned o ;
however, all other control functions can be
activated.
Temperature Lock
Once you have set the desired water
temperature, you may lock-in the new
setting to prevent unauthorized temperature
adjustments to your Swim Spa. To lock the set
temperature:
Touch UP or DOWN, then touch TIME, JETS 1,
and UP within 3 seconds. The ‘TL’ indicator will
light when the set temperature is locked.
Temperature Unlock
To unlock the temperature, touch either UP or
DOWN, then touch TIME, JETS 1, and DOWN
within 3 seconds. The ‘TL’ indicator light will go
out when the set temperature lock is cleared.
Panel Lock
To help prevent unauthorized use of your
Swim Spa, the control system has a unique
panel locking system. To lock the panel, touch
TIME, JETS 1, then UP within 3 seconds.
When locked, the ‘PL’ indicator light will be
on. Except for the time button, all function
settings will be frozen.

MAAX xstream Specifications

General

Brand	MAAX
Model	xstream
Category	Hot Tub
Language	English