EasyManuals Logo
Home>Mahindra>Tractor>10 Cab Series 4510C

Mahindra 10 Cab Series 4510C User Manual

Mahindra 10 Cab Series 4510C
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
21
Operating the tractor
1. Before starting the tractor apply the parking brake, place the PTO (Power Take Off) lever in the
“OFF” position, the hydraulic control levers in the downward position, the remote control valve
levers in the neutral position( if fitted) and the transmission in neutral.
2. Do not start the engine or controls while standing besides the tractor. Always sit on the tractor
seat when the engine or operating controls.
3. Safety starter switch.
In order to prevent the accidental starting of the tractor, a safety switch has been provided. The
starting system of the tractor is connected through this switch, which becomes operative only when
the clutch pedal is depressed. On some models shuttle shifter lever and PTO button should also be in
neutral position for completing the starting circuit. Do not bypass the safety starter switch. Consult
your Mahindra Tractor Dealer/Distributor if safety- starting switch malfunctions.
4. Avoid accidental contact with the gear shifter lever while the engine is running. Unexpected
Tractor movement can result from such contact.
5. Do not get off or climb the tractor while it is in motion.
6. Shut off the engine, remove the key and apply the parking brake before getting off the tractor.
7. Do not operate the tractor in an enclosed building without adequate ventilation. Exhaust fumes can
cause death.
8. Do not park the tractor on a steep slope.
9. If power steering or Engine seizes to operate, stop the tractor immediately.
10. Pull only from the swinging draw bar or the lower link drawbar in the down position. Use only a
drawbar pin that locks in place. Pulling from the tractor rear axle carriers or any point above the
rear axle may cause the Tractor’s front end to lift.
11. If the front end of the tractor tends to rise when heavy implements are attached to the three-point
linkage, install front end or front wheel weights. Do not operate the tractor with a light front end.
12.Always use hydraulic position control lever when attaching equipments/implement and when
transporting equipment. Be sure that the hydraulic couplers are properly mounted and will
disconnect safely in case of accidental detachment of implement.
13.Do not leave equipment/implement in the raised position.
14.Use the flasher/ Turn signal lights and Slow Moving Vehicle (SMV) signs when driving on public
roads during both day and night time, unless prohibited by law.
15. Dim tractor lights when meeting a vehicle at night. Be sure the lights are adjusted to prevent the
blinding on the eyes of coming vehicle operator.
16.Emergency stopping instruction; If tractor fails to stop even after application of brakes, Pull the
knob of fuel shut off control rod.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mahindra 10 Cab Series 4510C and is the answer not in the manual?

Mahindra 10 Cab Series 4510C Specifications

General IconGeneral
BrandMahindra
Model10 Cab Series 4510C
CategoryTractor
LanguageEnglish

Related product manuals