Makita DTR180 Original Instructions

2 ENGLISH
SPECIFICATIONS
Model: DTR180
Tie wire (Optional accessory) ø0.8 mm
Diameter of rebars that can be tied From #3 x #3 to (#4 x 2) x (#4 x 2)
From 10 mm x 10 mm to (13 mm x 2) x (13 mm x 2)
Approximate number of ties per reel Approximately 120 ties
Overall length 304 mm
Rated voltage D.C. 14.4/18 V
Net weight 2.3 - 2.6 kg
• Duetoourcontinuingprogramofresearchanddevelopment,thespecicationshereinaresubjecttochange
without notice.
• Specicationsandbatterycartridgemaydifferfromcountrytocountry.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge D.C.14.4 V Model BL1415N / BL1430 / BL1430B / BL1440 / BL1450 / BL1460B
D.C.18 V Model BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
andchargersmaycauseinjuryand/orre.
Combination of rebars that can be tied
Combination of 2 rebars
#3 (10 mm) #4 (13 mm) #5 (16 mm)
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 3 rebars
#3 x #3 (10 mm x 10 mm) #4 x #4 (13 mm x 13 mm)
#3 (10 mm)
#4 (13 mm)
#5 (16 mm) -
Combination of 4 rebars
#3 x #3 (10 mm x 10 mm) #4 x #4 (13 mm x 13 mm)
#3 x #3 (10 mm x 10 mm)
#4 x #4 (13 mm x 13 mm)
NOTICE: If there is a gap between rebars or if the tool is used at an incorrect orientation, the rebars may not be
able to be tied.

Makita DTR180 Specifications

General

Brand	Makita
Model	DTR180
Category	Power Tool
Language	English