28
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formedregularly.Guaranteeclaimscanberecognizedonlyifthisworkisperformedregularlyandproperly.Failuretoperformthe
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a MAKITA service centre.
Service, spare parts and guarantee
Maintenance and repair
Themaintenanceandrepairofmoderncutoffsawsandtheirsafety-relatedcomponentsrequiresqualiedtechnicaltraininganda
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service centre for all work not described in this instruction manual.
The MAKITA service centres have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Tondyourlocaldistributor,pleasevisitwww.makita-outdoor.com
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts
used. Use only original MAKITA parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materi-
als, dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA
product guarantee.
We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts.
Page
General Entire Power Cut Clean exterior, check for damage. In case of damage,
haverepairedbyaqualiedservicecentreimmediately
Cutting disc Inspect regularly for damage and wear. 6
Clutch Have inspected at a service center.
Protection hood Clean, Check position (impact plate) 16
Before each start Cutting disc Inspect for damage and make sure the cutting wheel is 6
right for the job
V-belt Check V-belt tension 14
Protective hood Adjust position
Combination switch, Functional check
Safety locking button, Functional check
Throttle lever Functional check 17
Tank cap Check for tightness
Every day Airlter Clean(ifnecessarymorefrequently);pre-lter(foam)
maintenance as described above under Cleaning /
changing the air lter 20-21
Idle speed Check (cutting disc must not turn on idle) 18
Every week Starter housing Clean to ensure proper air cooling 12
Starter cable Check for damage 23
V-belt Check V-belt tension, inspect for damage and wear 14, 19
Airlterinsert Clean,replaceafter100operatinghours 21
Spark plug Check and replace if necessary 22
Mufer Checktightnessofmounting 12
Spark arrester screen Clen and replace if necessary 26
Screwsandnuts Checktheirconditionandthattheyarermlysecured.
Every 3 months Suction head Replace 22
Fuel tank Clean
Annually EntirePowerCut Checkatanauthorizedservicecentre
Storage Entire Power Cut Clean exterior, check for damage. In case of damage,
haverepairedbyaqualiedservicecentreimmediately
Cutting disc Remove and clean 13
Fuel tank Empty and clean
Carburetor Run empty
To Next Page
Loading...
Need help?
General
Weight and Dimensions
