3-23
H OCCASIONAL MAINTENANCE
H1 - Wheels
CHANGE
- Stop the lifting platform on a firm horizontal surface, if possible.
- Proceed to switch off the lifting platform (see: 1 - SAFETY INSTRUCTIONS AND ADVICE:
INSTRUCTIONS ON DRIVING LADEN AND UNLADEN).
- Place chocks under the lifting platform in both directions.
- Loosen the wheel nuts fully and remove them.
- Free the wheel by tugging it from one side and then the other and roll it off to one
side.
- Slide the new wheel onto the hub.
- Screw on the nuts by hand.
- Tighten the nuts with a torque wrench.
H2 - Replacing the batteries
REPLACE
When the batteries must be replaced, it is essential to use batteries of the same capacity
and weight as the original batteries to ensure the machine’s stability.
Do not use batteries with a lower weight than the original ones. The
batteries serve as a counterweight and are essential to the machine’s
stability. Each battery must weigh 29.5 kg. Each battery tray must weigh
at least 152 kg (including the batteries).
PRECAUTIONS :
- Keep the battery upright when lifting it.
- Ensure that the slings are kept apart from each other to avoid a short-circuit.
- Ensure that the batteries are correctly positioned on the lifting platform.
647369 (01/03/2017)
78/100 SEC 2 / 120 SE 2
To Next Page
Loading...
Need help?
General