EasyManuals Logo
Home>Manitowoc>Construction Equipment>Grove RT540E

Manitowoc Grove RT540E User Manual

Manitowoc Grove RT540E
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #124 background imageLoading...
Page #124 background image
SET-UP AND INSTALLATION PROCEDURES RT540E OPERATOR MANUAL
4-10 Published 01-15-2016, Control # 526-01
ERECTING AND STOWING THE BOOM
EXTENSION
General Warnings
NOTE: Tag line used in these procedures is to control the
movement of the boom extension.
Securing the Boom Extension with Tag Line (Rope)
NOTE: A tag line attached to the tip of the extension is
used to control the movement of the boom
extension.
The extension may swing out on its own accord when you
remove the last connection that held the extension at the
side of the main boom.
You must therefore secure the extension before you begin
the erection procedure.
Secure the boom extension as follows:
Attach a tag line (rope) at the front of the extension.
Have a helper hold the tag line (rope) tight while you
are removing the last connection.
NOTE: If you are alone, secure the other end of the tag line
(rope) on the crane (e.g., on the steps of the
access ladder or to the superstructure. Leave
enough play in the tag line that it is tight only when
you swing the extension towards the main boom
head later in the procedure.
Erecting
1. Visually check to ensure all pins are installed.
2. Crane should be set up on outriggers using normal
setup procedures. Refer to Section 3 - OPERATING
CONTROLS and PROCEDURES.
a. Fully retract boom.
b. Lower boom to horizontal for erecting over the front
of the crane.
NOTE: The auxiliary boom nose (rooster sheave) does not
have to be removed. However, if reeved, the hoist
cable must be removed from the sheave.
3. Rig either the main hoist or optional auxiliary hoist cable
for single part line with nothing but the wedge socket on
the end of the cable. Refer to Cable Reeving and Dead
End Rigging in this section.
4. Remove the retainer clips from the right side attachment
pins (1) stowed in the base of the boom extension (2)
and remove the attachment pins from the boom
extension. Insert the right side attachment pins (1)
through the boom attachment and boom extension
anchor fittings. Install the retainer clips in the attachment
pins. (Figure 4-9)
DANGER
To prevent serious injury or death, always wear personal
protective equipment; i.e., a hard hat, eye protection,
gloves and metatarsal boots.
DANGER
Boom angles are used to control speed at which
extensions swing during erecting and stowage. Improper
boom angles will cause uncontrollable swing speeds of
extension.
DANGER
Before attempting to erect or stow the boom extension;
read and strictly adhere to all danger decals installed on
the boom/boom nose, boom extension, and stowage
brackets.
DANGER
Always secure the boom extension with a tag line (rope)
on the main boom before removing any connections. This
will prevent the extension from swinging around and
knocking you off the carrier or injuring other persons in the
swing range.
DANGER
To prevent serious injury or death, do not stand on
decking until extensions are secure.
Reference Only

Table of Contents

Other manuals for Manitowoc Grove RT540E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Grove RT540E and is the answer not in the manual?

Manitowoc Grove RT540E Specifications

General IconGeneral
BrandManitowoc
ModelGrove RT540E
CategoryConstruction Equipment
LanguageEnglish

Related product manuals