EasyManuals Logo
Home>Manitowoc>Construction Equipment>Grove RT880E

Manitowoc Grove RT880E User Manual

Manitowoc Grove RT880E
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
BOOM RT880E SERVICE MANUAL
4-4 Published 11-10-2014, Control # 524-00
31. Remove the capscrews and washers securing the bot-
tom rear wear pad to the inner mid and remove the wear
pad and spacer.
32. If necessary, remove both grease fittings, connectors,
and grease lines from the rear of the inner mid.
33. Continue to pull the assembly from the center mid,
removing the top rear wear pads from the outer mid sec-
tion as they clear the inner mid.
34. Remove the capscrews and washers securing each
retract cable sheave mount in the rear of the outer mid.
Remove the retract cable sheave mounts from the rear
of the outer mid section; remove retract sheaves.
35. Place blocking under the lower and upper cylinder bar-
rel.
36. Remove the capscrews and washer securing each
upper cylinder barrel trunnion mounting plate to the
outer mid.
37. Slide the assembly out of the outer mid part way.
38. Remove the bolts and washers and the two set screws
and locknuts securing each front top wear pad to base
section. Remove two bolts and washers securing each
adjusting plate to top of base section. Remove two
adjusting plates. Remove upper wear pad assembly. If
necessary, remove four bolts securing front upper wear
pad to pad plate.
39. Remove the capscrews and washers securing the bot-
tom and side wear pad keeper plates to the outer mid.
Remove the keeper plates.
40. Lift up on the front of the fly section and remove the bot-
tom and side wear pads and shims from the outer mid,
noting quantity, size, and location of shims.
41. Continue to pull the assembly from the outer mid,
removing the top rear wear pads from the fly section as
they clear the inner mid.
42. Remove the capscrews securing the rear side wear
pads to the fly section. Remove the wear pads and
shims, noting quantity and size of shims.
43. Remove the capscrews and washers securing the bot-
tom wear pad to the outer mid and remove the wear pad
and shim.
44. If necessary, remove both grease fittings, connectors,
and grease lines from the rear of the outer mid.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Grove RT880E and is the answer not in the manual?

Manitowoc Grove RT880E Specifications

General IconGeneral
BrandManitowoc
ModelGrove RT880E
CategoryConstruction Equipment
LanguageEnglish

Related product manuals