EasyManuals Logo
Home>Manitowoc>Construction Equipment>Grove RT880E

Manitowoc Grove RT880E User Manual

Manitowoc Grove RT880E
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #305 background imageLoading...
Page #305 background image
Grove Published 11-10-2014, Control # 524-00 9-1
RT880E SERVICE MANUAL LUBRICATION
9
SECTION 9
LUBRICATION
SECTION CONTENTS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-1
Environmental Protection . . . . . . . . . . . . . . . . . . . 9-1
Lubrication Intervals . . . . . . . . . . . . . . . . . . . . . . . 9-1
Standard Lubricants. . . . . . . . . . . . . . . . . . . . . . . . 9-2
Arctic Lubricants and Conditions . . . . . . . . . . . . . 9-3
Surface Protection for Cylinder Rods. . . . . . . . . . 9-6
Wire Rope Lubrication . . . . . . . . . . . . . . . . . . . . . . 9-7
Lubrication Points . . . . . . . . . . . . . . . . . . . . . . . . . 9-7
CraneLUBE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-7
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-7
Steering and Suspension . . . . . . . . . . . . . . . . . . . 9-8
Axles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-10
Drive Train . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-12
Drive Train (continued) . . . . . . . . . . . . . . . . . . . . 9-15
Turntable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-17
Cab Tilt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-19
Outriggers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-21
Boom . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-23
Boom (continued) . . . . . . . . . . . . . . . . . . . . . . . . 9-25
Boom (continued) . . . . . . . . . . . . . . . . . . . . . . . . 9-27
Hoist. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-29
Hydraulic . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-31
Diesel Exhaust Fluid (DEF) . . . . . . . . . . . . . . . . . 9-33
Carwell® Rust Inhibitor . . . . . . . . . . . . . . . . . . . . 9-35
Protecting Cranes From Rusting . . . . . . . . . . . . . 9-35
Cleaning Procedures . . . . . . . . . . . . . . . . . . . . . . 9-35
Inspection and Repair . . . . . . . . . . . . . . . . . . . . . 9-36
Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-36
Areas of Application. . . . . . . . . . . . . . . . . . . . . . . 9-36
GENERAL
Following the designated lubrication procedures is important
in ensuring maximum crane lifetime and utilization. The
procedures and lubrication charts in this section include
information on the types of lubricants used, the location of
the lubrication points, the frequency of lubrication, and other
information.
ENVIRONMENTAL PROTECTION
Dispose of waste properly! Improperly disposing of waste
can threaten the environment.
Potentially harmful waste used in Manitowoc cranes includes
— but is not limited to — oil, fuel, grease, coolant, air
conditioning refrigerant, filters, batteries, and cloths which
have come into contact with these environmentally harmful
substances.
Handle and dispose of waste according to local, state, and
federal environmental regulations.
When filling and draining crane components, observe the
following:
Do not pour waste fluids onto the ground, down any
drain, or into any source of water.
Always drain waste fluids into leak proof containers that
are clearly marked with what they contain.
Always fill or add fluids with a funnel or a filling pump.
Immediately clean up any spills.
LUBRICATION INTERVALS
The service intervals specified are for normal operation
where moderate temperature, humidity, and atmospheric
conditions prevail. In areas of extreme conditions, the
service periods and lubrication specifications should be
altered to meet existing conditions. For information on
extreme condition lubrication, contact your local Manitowoc
Cranes distributor or Manitowoc Crane Care.
Lube intervals are to be used as a guideline only. Actual lube
intervals should be formulated by the operator to correspond
according to conditions such as continuous duty cycles and/
or hazardous environments.
CAUTION
Chassis grease lubricants must not be applied with air
pressure devices, as this lubricant is used on sealed
bearings.
The multipurpose grease installed during manufacture is
of a lithium base. Use of a noncompatible grease could
result in damage to equipment.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Grove RT880E and is the answer not in the manual?

Manitowoc Grove RT880E Specifications

General IconGeneral
BrandManitowoc
ModelGrove RT880E
CategoryConstruction Equipment
LanguageEnglish

Related product manuals