50 Part Number 000014141 Rev 11 12/23
Maintenance Section 4
Step 11 Use half of the sanitizer/water
solution to sanitize all food zone surfaces
of the ice machine and bin (or dispenser).
Use a spray bottle to liberally apply the
solution. When sanitizing, pay particular
attention to the following areas:
• Side walls
• Base (area above water trough)
• Evaporator plastic parts ‑ including top,
bottom and sides
• Bin or dispenser
Do not rinse the sanitized areas.
Step 12 Replace all removed components
back into their original configuration and
wait 20 minutes.
Notice
When re‑installing the water level probe,
ensure the rubber gasket is sealed against
the base of the ice machine and that any
electrical connectors or wires remain free
from moisture.
Step 13 Press the Clean button and
select “Make ice when complete”. Water
will flow through the water dump valve
and down the drain. Wait approximately
1 minute until the water trough refills and
the display indicates Add Chemical. Add the
proper amount of ice machine sanitizer to
the water trough by pouring between the
water curtain and evaporator, then confirm
the chemical was added.
Model
Amount of
Sanitizer
IT0300/IP0320
IT0420/IT0450
IT0500/IF0500/IP0500
IF0600/IF0600C/IT0620
IBF0620C/IT0750/IBF0820C
IF0900/IF0900C
IT0900/IT1200/IT1200C
3 oz
(90 ml)
IBT1020C
3.5 oz
(104 ml)
IT1500/IT1900
6 oz
(180 ml)
IF1400C/IT1430C
IF1800C/IT1830C
IF2100C/IT2130
12 oz
(355 ml)
Step 14 Close and secure the front panel.
The ice machine will automatically start ice
making after the sanitize cycle is complete
(approximately 24 minutes).
Parts Removal for Detailed De‑scaling
and Sanitizing
Single evaporator is shown; Each
evaporator will have a distribution tube and
water curtain/damper.
Notice
Electrical connector must never be
exposed to any liquids.
To Next Page
Loading...
Need help?
General