CONTROLS AND OPERATING PROCEDURES OPERATOR MANUAL NBT50
3-24 Published 03-23-2018 Control # 243-14
Operation
The remote control operates only when the crane is running
and the “Crane Power” switch is turned OFF, the boom
length is less than 10ft extended, and the boom angle is less
than 10 degrees.
To use this remote, the ON/Horn button must be pressed to
turn on the remote and a second time to activate the remote.
The crane horn will sound as confirmation that the remote is
now active. The remote can now be used to control the
hoist(s) and front outrigger.
To activate a function press and hold the button that
corresponds to the desired movement until you desire the
function to stop.
For each button press and hold, the crane will allow for
several seconds of continuous movement. To move the
function more, press and hold the button again.
When finished with the remote, press the red STOP button.
This will only turn off the remote; it will not shut off the
machine.
If the remote is left turned on for more than 5 minutes, the
remote will shut itself off.
If any interference is present in the area and the remote does
not function properly, the radio's channel can be changed.
This is done by pressing and holding the ON/Horn button
while momentarily pressing the Frequency Change button.
Once finished using this remote, it can be stored and
charged in the 12V charging base located in the crane cab
on the load chart manual holder.
Item Description
1 Display - Channel Number Codes
2 ON/Horn
3 Blank
4 Center Front Stabilizer Extend
5 Auxiliary Hoist Down
6 Main Hoist Down
7648-2
FIGURE 3-17
1
2
3
4
5
6
7
8
9
10
11
12
7 Main Hoist Up
8 Auxiliary Hoist Up
9 Center Front Stabilizer Retract
10 Blank
11 Frequency Change
12 Stop/Off
Item Description
To Next Page
Loading...
Need help?
General
