Operation
410/420/430 - 001 8903 U1
UZEL
43
Power take-off (PTO)
WARNING: PTO shafts and PTO driven
implements can be extremely
hazardous, observe the following
important points:
*DO NOT operate the tractor without a PTO cap
fitted when not using the PTO. It protects people
from injury as well as the splines from damage.
*Before attaching, adjusting or working on PTO
driven implements, disengage the PTO, stop
the engine and remove the key. DO NOT work
under raised equipment.
*Before engaging a PTO driven implement and
after fitting, ALWAYS carefully raise and lower
the implement using Position Control, and
check clearances, PTO shaft slide range and
articulation.
*Ensure that the PTO safety shield is in place
at all times.
*Ensure that all PTO driven implements have
the correct guards, are in good condition and
conform to current standards.
*NEVER step across any driveline.
*DO NOT use the tractor drawbar or the
implement drawbar as a step.
*NEVER use the driveline as a step.
*NEVER wear loose fitting clothes.
*Keep at least your height away from a rotating
drive line.
There are two types of Power Take-Off (PTO)
available, Direct Drive from the engine using a dual
clutch and mechanical engagement (MF 410 only).
The second type ( MF410/420/430 ) is an Independent
Power Take -Off (IPTO) using a single split torque
clutch and hydraulic engagement.
PTO cap
PTO shield
Fig. 53
To Next Page
Loading...
Need help?
General
