Matrix E7XI-01 User Manual

114
9.21 CF CARD REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
NOTE: IftheCFcardhasbeenusedinadifferent7xiconsole,itcannotbereusedinanotherconsole.ToreuseaCFcard,itneedsto
gothroughaspecialprocessbytheMatrixServiceTeam.
1) Turn on the power to the Elliptical Trainer, wait until the welcome display picture has been come up (Figure A).
2) Enter Manager Mode by pressing ENTER, 1, 0, 0, 1, ENTER on the entertainment keypad.
3)
Record the Accumulated Mileage, Accumulated Time, and Serial Number.
4)
Press the HOME key to return to the welcome display picture.
5) Turn off power and disconnect the cord from the machine.
6)
Remove the console from frame as outlined in Section 9.10 and remove the back cover of the console (Figure B).
7) The console shell will now separate. Remove the two screws holding the iron plate to the console frame (Figure C).
8) Carefully remove the CF card from the console frame (Figure D).
9) Reverse Steps 7-8 to install a new CF card.
10)Turn
on the power to the Suspension elliptical Trainer. Wait about 8 minutes until the 7xi Setup Wizard display picture has come up. Select
the correct model on the model setup. Touch the Left / Right arrow to switch the setting. Continue with the language setting, date / time setting,
asset management setting and serial number setting. If the display shows 04A0, disable all errors by pressing ENTER, 3, 0, 0, 8, ENTER on the
entertainment keypad. Reboot the console by pressing ENTER, 7, 3, 2, 6, 6, 8 ENTER on the entertainment keypad. Wait about 3 minutes until
the welcome display picture has come up. If the display shows 04A0, turn off the machine and wait 30 seconds, then turn the machine back on.
NOTE:Don’tpoweroffthemachinewhilethesoftwareisbeinginstalled.
11)Enter Service Mode by pressing ENTER, 3, 0, 0, 1, ENTER on the entertainment keypad and press the general key on the screen. Check if
the software versions are correct. Enter Service Mode by pressing ENTER, 3, 0, 0, 2, ENTER on the entertainment keypad and select the
correct model if necessary.
12)Perform a software upgrade as outlined in Section 11.
13)Enter Service Mode by pressing ENTER, 3, 0, 0, 1, ENTER on the lower keypad. Check the general settings, weather setting, applications
setting and virtual active setting. Performing the TV programming as outlined in Section 10.5.
14)Test the Suspension elliptical Trainer for function as outlined in Section 9.23.
FIGURE BFIGURE A
FIGURE DFIGURE C

Matrix E7XI-01 Specifications

General

Brand	Matrix
Model	E7XI-01
Category	Elliptical Trainer
Language	English