162
CHAPTER 11: SOFTWARE UPGRADE INSTRUCTIONS
11.1 SOFTWARE UPGRADE PROCEDURE FROM WEBSITE
NOTE:Don’tpoweroffthemachinewhilethesoftwareisbeinginstalled.Afterthesoftwarehasbeen
installedcompletely,turnoffthemachineandwait30seconds,thenturnthemachinebackon.Ifthe
displayshows04A0,turnoff&turnonthemachineagain.
1) Turn on the power to the Elliptical, wait until the welcome display picture has been come up (Figure A).
2) Enter Manager Mode by pressing ENTER, 1, 0, 0, 1, ENTER on the lower keypad.
3) Record the Accumulated Mileage, Accumulated Time, and Serial Number. NOTE: The information can be lost during the update procedure
and should be recorded so that the information can be entered into the newly updated console.
4) Press the HOME key to return to the welcome display picture.
5) Enter Update manager by pressing ENTER, 3, 0, 0, 4, ENTER on the lower keypad.
6) Press the Settings key on the screen. Then select the "HTTP" update source (Figure B).
7) Press the Available Updates key on the screen. (Figure C).
FIGURE A FIGURE B
FIGURE C
To Next Page
Loading...
Need help?
General
