Matrix E7XI-01 User Manual

91
9.3 LOWER CONTROL BOARD REPLACEMENT
1) Turn off the power and disconnect the cord from the machine.
2) Remove both front disks from the machine as outlined in Section 9.1.
3) Disconnect all wires from the LCB (Figure A).
4) Remove the 2 screws holding the LCB to the frame (Figure B).
5) Reverse Steps 1-4 to install a new LCB.
6) Test the Suspension Elliptical for function as outlined in Section 9.23.
FIGURE A
FIGURE B
CHAPTER 9: PART REPLACEMENT GUIDE

Matrix E7XI-01 Specifications

General

Brand	Matrix
Model	E7XI-01
Category	Elliptical Trainer
Language	English