Matrix MX-A5x Service Manual

37
5. Remove backing from new keypad. (Figure F) Install new keypad
by sliding ribbon through console and aligning keypad with console
house – press into place.
6. Attach keypad ribbon to console board by pressing carefully into
place. (Figure G)
7. Remove the backing from new overlay(s). (Figure H) Align with
console housing and press into place being careful to avoid air
bubbles and misalignment.
8. Replace the back of the console 6 screws and re-install the console
onto the mast of the machine (Figure I). Plug in and test the
machine as outlined in section 9.99.
9.8.1 CONSOLE – OVERLAYS & KEYPADS – REMOVAL
AND INSTALLATION - CONTINUED
Figure F
Figure G
Figure H
CHAPTER 9: PART REPLACEMENT GUIDE
Figure I

Matrix MX-A5x Specifications

General

Brand	Matrix
Model	MX-A5x
Category	Elliptical Trainer
Language	English