Matrix MX-A5x Service Manual

CHAPTER 9: PART REPLACEMENT GUIDE
9.14 REAR PIVOT ARM REMOVAL AND INSTALLATION
1. Turn o power and disconnect the cord from the machine.
2. Remove the rear plastic covers as outlined in Section 9.9.
3. Remove the bolts holding the rear pivot arm to the motor
(Figure A).
4. Remove the 4 bolts that hold the upper arm assembly to the rear
pivot arm (Figure B) and carefully swing the upper arm assembly
forward and out of the way.
5. Remove the pivot shaft bolt and taper washer from the pivot
assembly. (Figure C).
6. Remove the pivot shaft and rear pivot arm from the frame.
(Figure D).
7. Reverse steps 2-6 to reassemble with new pivot arm components.
Make sure to transfer the plastic covers and any necessary
hardware from the original arm assembly. Tighten the pivot shaft
bolt to 40 N-m torque. Test machine as outlined in section 9.99.
Figure A
Figure B
Figure C Figure D

Matrix MX-A5x Specifications

General

Brand	Matrix
Model	MX-A5x
Category	Elliptical Trainer
Language	English