58
11.4 INSTALLING ADJUSTABLE TENSIONER CONTINUED
9. Thread the two cable ties through the bottom holes in the alignment
block and around all of the components.
10. Grab the tail end of each cable tie and pull the cable tie VERY tight,
stretching it around the componenets. As the cable tie is held tight,
push the zipper portion toward the roller to lock the tension in.
11. Grasp the pulley on the opposite side of the machine from the
small pulley and rotate it back and forth slightly to confirm that the
components are all seated tightly against each other.
12. Grasp the pulley on the opposite side of the machine from the small
pulley and rotate this back and forth slightly and gently as you make
these bolts finger-tight. Finger-tighten the 2 bolts on the bottom of the
bracket assembly and then the three bolts on the side.
To Next Page
Loading...
Need help?
General
