Matrix W1X ROWER User Manual

20
6.10 ROPE AXLE SET REPLACEMENT
CHAPTER 6: PART REPLACEMENT GUIDE
1) Remove the front shrouds as outlined in Section 6.1.
2) Remove the middle shrouds as outlined in Section 6.2.
3) Remove the console as outlined in Section 6.3.
4) Remove the handlebar from the rope as outlined in Section 6.4.
5) Remove the rubber center cover as outlined in Section 6.5.
6) Remove the plastic center cover as outlined in Section 6.6.
7) Remove the rubber ball from the end of the rope (Figure A).
8) Allow the rope to coil around the rope axle set.
9) Remove the 3 screws holding the spin axle in place on both sides and remove the spin axles (Figures B & C).
10) Loosen the tension on the belt by loosening the eye bolt nuts on the center axle set (Figures D & E).
11) Remove the 3 screws holding the rope axle set to the frame on both sides (Figure F).
12) Remove the rope axle set (Figure G).
13) Reverse Steps 1-13 to install a new rope axle set.
13) Test the rower for function as outlined in Section 6.19.
FIGURE A
FIGURE B
FIGURE C

Matrix W1X ROWER Specifications

General

Brand	Matrix
Model	W1X ROWER
Category	Elliptical Trainer
Language	English