Matrix W1X ROWER User Manual

27
6.14 CENTER AXLE REPLACEMENT
CHAPTER 6: PART REPLACEMENT GUIDE
1) Remove the front shrouds as outlined in Section 6.1.
2) Remove the middle shrouds as outlined in Section 6.2.
3) Remove the console as outlined in Section 6.3.
4) Remove the handlebar from the rope as outlined in Section 6.4.
5) Remove the rubber center cover as outlined in Section 6.5.
6) Remove the plastic center cover as outlined in Section 6.6.
7) Remove the rubber ball from the end of the rope (Figure A).
8) Allow the rope to coil around the rope axle set.
9) Remove the eye bolts that apply tension to the belt (Figures B & C).
10) Remove the 2 screws holding the speed sensor to the frame (Figure D).
11) Remove the 4 screws holding the magnet set to the frame (Figure E).
12) Remove the 4 screws holding the wheel cover to the frame (Figures F & G), this will allow you to remove the wheel covers / center axle from the
frame (Figure H).
13) Peel up the rubber center strip, and remove the screws holding the 2 sides of the wheel cover together (Figure I).
14) Remove the center axle.
15) Reverse Steps 1-14 to install a new center axle.
16) Test the rower for function as outlined in Section 6.19.
FIGURE A
FIGURE B
FIGURE C

Matrix W1X ROWER Specifications

General

Brand	Matrix
Model	W1X ROWER
Category	Elliptical Trainer
Language	English