194
Controls in detail
Power windows
Fully closing the door windows
(Express-close)
왘 Pull switch 1 or 2 past the resis-
tance point and release.
The corresponding door window closes
completely.
If the upward movement of the door win-
dow is blocked during the closing proce-
dure, the door window will stop and open
slightly.
Stopping windows
왘 Press or pull the respective switch
again.
Closing the windows with
KEYLESS-GO*
왘 Press and hold lock button on an out-
side door handle (
컄 page 62) until the
windows are closed.
Synchronizing power windows
The power window must be resynchro-
nized each time
ì•« after the battery has been disconnect-
ed
ì•« if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing the power windows
왘 Switch on the ignition (컄 page 36).
왘 Pull the power window switches until
the side windows are closed.
Hold the switches for approximately
1 second.
The power windows are synchronized.
Warning! G
Driver’s door only:
If within 5 seconds the switch is again
pulled past the resistance point and re-
leased, the automatic reversal will not
operate.
Warning! G
When closing the windows make sure that
there is no danger of anyone being harmed
by the closing procedure.
The windows will not automatically re-open
if blocked during convenience closing.
If potential danger exists, proceed as fol-
lows:
ì•« Release the lock button.
ì•« Pull on the door handle and hold firmly.
The side windows open for as long as
the door handle is held but the door not
opened.
To Next Page
Loading...
Need help?
General
