423
Practical hints
Towing the vehicle
Installing towing eye bolt
Front of vehicle
1 Cover on right side of front bumper
To remove cover:
왘 Press mark on cover 1 in direction of
arrow.
왘 Lift cover 1 off to reveal the threaded
hole for towing eye bolt.
The towing eye bolt is supplied with the
tool kit (located in the storage compart-
ment under the trunk floor).
!
When towing the vehicle with all wheels
on the ground, please note the follow-
ing:
With the automatic central locking acti-
vated and the SmartKey in starter
switch position 2, or KEYLESS-GO*
start/stop button in position 2, the ve-
hicle doors lock if the left front wheel
as well as the right rear wheel are turn-
ing at vehicle speeds of approx. 9 mph
(15 km/h) or more.
To prevent the vehicle door locks from
locking, deactivate the automatic cen-
tral locking (
컄 page 112).
Towing of the vehicle should only be
done using the properly installed tow-
ing eye bolt. Never attach tow cable,
tow rope or tow rod to the vehicle chas-
sis, frame or suspension parts.
i
If the battery is disconnected or dis-
charged
앫 the SmartKey will not turn in the
starter switch
앫 the gear selector lever will remain
locked in position P.
For more information, see “Batteries”
(
컄 page 413) and
“Jump starting” (
컄 page 419).
컄컄
To Next Page
Loading...
Need help?
General
