Rear Seat Cushion
Removal: Push in locking tabs (1)
(on left and right side of seat) and
pull up seat at the front.
Installation: Slide rear edge of
cushion under the backrest so that
both wire loops under the backrest
engage at the seat cushion. Push
front of cushion down until it locks
in place.
Caution!
Watch out for sharp edges when
removing or installing the rear seat
cushion, to prevent injury.
Front Head Restraints
The release button (1) is located
below the left head restraint post
on both front seats.
Removal:
Bring the head restraint to its
highest position.
Depress release button (1) be
neath the seatback covering
material and pull head restraint up
sharply, holding it by the left head
restraint post (viewed in driving
direction). Then pull out head
restraint completely with both
hands.
Installation:
Insert the head restraint and push
it down to the stop.
Check if the highest position can
be reached by pushing the switch
up for approximately 5 seconds.
Adjust head restraint to the de
sired position.
Warning!
For your protection, drive only
with properly positioned head
restraints.
Do not drive the vehicle with
out the seat head restraints.
Head restraints are intended to
help reduce injuries during an
accident.
For positioning of head restraints
refer to sections Power Seats,
Front, and Head Restraints, Rear
in Index.
102
To Next Page
Loading...
Need help?
General
