X
To switch on the standing lamps: the
SmartKey is not in the ignition lock or it is in
position 0.
X
Turn the light switch to W (left-hand side
of the vehicle) or X (right-hand side of
the vehicle).
Combination switch
Turn signal
:
High-beam headlamps
;
Turn signal, right
=
High-beam flasher
?
Turn signal, left
X
To indicate briefly: press the combination
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
X
To indicate: press the combination switch
beyond the pressure point in the direction
of arrow ; or ?.
High-beam headlamps
X
To switch on manually: turn the Smart-
Key to position 2 in the ignition lock or start
the engine.
X
Vehicles without Adaptive Highbeam
Assist: turn the light switch to L or
Ã.
X
Vehicles with Adaptive Highbeam Assist:
turn the light switch to L.
X
Press the combination switch beyond the
pressure point in the direction of arrow :.
In the à position, the high-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
X
To deactivate: move the combination
switch back to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active, it
automatically controls activation of the high-
beam headlamps (Y page 125).
High-beam flasher
X
To switch on: turn the SmartKey in the
ignition lock to position 1 or 2, or start the
engine.
X
Pull the combination switch in the direction
of arrow =.
Hazard warning lamps
X
To switch on the hazard warning lamps:
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the corre-
sponding side of the vehicle will flash.
X
To switch off the hazard warning lamps:
press button :.
124
Exterior lighting
Lights and windshield wipers
To Next Page
Loading...
Need help?
General
