Display messages
Possible causes/consequences and MM Solutions
¨
Vehicle RisingVehicle Rising
Please WaitPlease Wait
The vehicle level is too low when the vehicle is stationary. A warn-
ing tone also sounds.
X
Do not pull away.
The vehicle level is set when the display message disappears.
¨
Stop Vehicle Vehi‐Stop Vehicle Vehi‐
cle Too Lowcle Too Low
You have pulled away while the vehicle level is still too low.
AIRMATIC sets the vehicle to the selected level after a short
period.
X
Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
X
Secure the vehicle against rolling away (Y page 170).
X
Wait until the display message disappears before pulling away.
AIRMATIC is defective. A warning tone also sounds.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Make only slight steering movements. Otherwise, the front
fender or the tires could be damaged if the steering movement
is too large.
X
Listen for scraping sounds.
X
Pull over and stop the vehicle safely, paying attention to road
and traffic conditions, and set a higher vehicle level.
Depending on the malfunction, it may be possible to raise the
vehicle.
X
Visit a qualified specialist workshop.
¨
MalfunctionMalfunction
The AIRMATIC function is restricted. The vehicle's handling char-
acteristics may be affected.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Visit a qualified specialist workshop.
ë
OffOff
The HOLD function is deactivated. The vehicle is skidding.
A warning tone also sounds.
X
Reactivate the HOLD function later (Y page 191).
262
Display messages
On-board computer and displays
To Next Page
Loading...
Need help?
General
